Installation Manual

BSLL-150/450/800 with BSLLUMNT1-2 Mount

• Start by clamping two “V” block on the mounting mast with the two 8” bolts, two lock washers and two nuts.

  NOTE: Maximum diameter for support and base pipes = 2.5″ (6.35 cm)

• Slide the two remaining “V” block on the bolts. In the same orientation as shown in the pictures. Secure them with the two remaining lock washers and nuts without tightening.

• Slide the antenna down between the last two “V” blocks installed, and now tighten the nuts.
  
  DO NOT OVERTIGHTEN: Tighten nuts to 5 lbs/ft (6.8 Nm)